Anionic polyacrylamide is the largest and most widely used in the same product range and can not be used as a water treatment material. It is also an important multifunctional additive, such as its good thickening properties, Anionic Polyacrylamide Many industries are added as thickeners. At the same time to participate in the product manufacturers are more, the main reason is that the product production process is simple, the processing accuracy is not high. But the added value of the product is low. Anionic Polyacrylamide If there is no large number of applications as a basis, it can have a big development. If only the production of this product is also difficult in the complex and volatile polymer flocculant market based.
Anionic polyacrylamide has two forms, Anionic Polyacrylamide one is white solid particles, the other is the emulsion form. Solid products can be divided into fine powder and particles, product molecular weight from 8 million to 25 million range, can be adjusted by adjusting the production of raw materials to adjust the formula. Can also be prepared to resist high temperature acid and alkali products, Anionic Polyacrylamide the use of water must be dissolved, but can not be dissolved in most organic solvents. Anionic Polyacrylamide Dry powder products are prepared after the transparent viscous liquid, Anionic Polyacrylamide emulsion type products are similar to the same milk diluted.
When used as a thickener, the anionic polyacrylamide can be formulated in any proportion, should be careful when adding to avoid the occurrence of agglomeration, the product through the mechanical, Anionic Polyacrylamide physical, chemical, From the neutralization and acid conditions are thickening effect, Anionic Polyacrylamide in the neutral and acid conditions are thickening effect. Anionic Polyacrylamide Zhengzhou billion liters reminded when the preparation of too high concentration will form a gel, then add water has been difficult to dissolve, need special attention.