1, before using cationic polyacrylamide emulsion products should be shaken as much as possible;
2, dissolution operation, while adding water edge of the product, dissolved concentration is recommended to control the 1-5 ‰, aging time of about 15-25 minutes is better;
3, to avoid the use of high-shear rotor pump centrifugal pump, the best use of screw pumps, diaphragm pumps and other low-shear pump;
4, dissolution operation should be plastic, ceramic, stainless steel and other materials in the tank, mixing speed should not be too large, without heating.
5, prepared a good dilute solution should not be long-lived, it is best to use with the dissolution;
6, polyacrylamide emulsion combined with inorganic coagulant Wastewater treatment, the inorganic coagulant should be added to be alum to be obvious when the (usually time interval of 30-60 seconds), then add this product, can not Reverse the order, nor can also be joined at the same time.
Previous: Physical and Chemical Properties of Polyacrylamide
Next: The scope of APAM
Related Industry Knowledge
- Environmental protection prospects ...
- Bright prospects for China polyprop...
- Pam main uses
- Amphoteric polyacrylamide for dry-s...
- Polyacrylamide decomposition method
- Pam not wearing gloves of any conse...
- Polyacrylamide gel electrophoresis ...
- Pam quickly dissolves in water method
- Cationic polyacrylamide why not use...
- Cationic polyacrylamide what harm
- Physical and Chemical Properties of...
- The purpose of APAM
Related Products

